Creating directories

Before we start creating directories, we need to check the base system's umask setting. To do this, we run umask. The result should be 022. If it isn't, then run the following command to ensure that the directories will be created with the correct permissions:

umask 022

We would advise you to make sure that the umask is set to 022 throughout your LFS installation.

Let's now create the directory tree on the LFS partition based on the FHS standard, which can be found at http://www.pathname.com/fhs/. Issuing the following commands will create a default directory layout:

cd $LFS
mkdir -p bin boot dev/pts etc/opt home lib mnt proc root sbin tmp var opt
for dirname in $LFS/usr $LFS/usr/local
���do
���mkdir $dirname
���cd $dirname
���mkdir bin etc include lib sbin share src var
���ln -s share/man man
���ln -s share/doc doc
���ln -s share/info info
���cd $dirname/share
���mkdir dict doc info locale man nls misc terminfo zoneinfo
���cd $dirname/share/man
���mkdir man{1,2,3,4,5,6,7,8}
done
cd $LFS/var
mkdir -p lock log mail run spool tmp opt cache lib/misc local
cd $LFS/opt
mkdir bin doc include info lib man
cd $LFS/usr
ln -s ../var/tmp tmp

Normally, directories are created with permission mode 755, which isn't desired for all directories. The first change is a mode 0750 for the $LFS/root directory. This is to make sure that not just everybody can enter the /root directory (the same a user would do with /home/username directories). The second change is a mode 1777 for the tmp directories. This way, any user can write data to the /tmp or /var/tmp directory but cannot remove another user's files (the latter is caused by the so-called "sticky bit" - bit 1 of the 1777 bit mask).

cd $LFS &&
chmod 0750 root &&
chmod 1777 tmp var/tmp

Now that the directories are created, copy the source files that were downloaded in chapter 3 to some subdirectory under $LFS/usr/src (you will need to create the desired directory yourself).