5.3. General Compilation Instructions
When building packages there are several assumptions made within the instructions:
-
Several of the packages are patched before compilation, but only when the patch is needed to circumvent a problem. A patch is often needed in both this and the next chapter, but sometimes in only one or the other. Therefore, do not be concerned if instructions for a downloaded patch seem to be missing. Warning messages about offset or fuzz may also be encountered when applying a patch. Do not worry about these warnings, as the patch was still successfully applied.
-
During the compilation of most packages, there will be several warnings that scroll by on the screen. These are normal and can safely be ignored. These warnings are as they appear—warnings about deprecated, but not invalid, use of the C or C++ syntax. C standards change fairly often, and some packages still use the older standard. This is not a problem, but does prompt the warning.
![[Important]](../images/important.png)
Important
After installing each package, delete its source and build directories, unless specifically instructed otherwise. Deleting the sources prevents mis-configuration when the same package is reinstalled later.
-
Check one last time that the
LFSenvironment variable is set up properly:echo $LFS
Make sure the output shows the path to the LFS partition's mount point, which is
/mnt/lfs, using our example. -
Finally, two last important items must be emphasized:
Important
The build instructions assume that the bash shell is in use.
Important
Before issuing the build instructions for a package, the package should be unpacked as user
lfs, and a cd into the created directory should be performed.
To re-emphasize the build process:
1. Place all the sources and patches in a directory that will be accessible
from the chroot envronment such as /mnt/lfs/sources/. Do not put
sources in /mnt/lfs/tools/.
2. Change to the sources directory.
3. For each package:
a. Using the tar program, extract the package to be built.
b. Change to the directory created when the package was extracted.
c. Follow the book's instructions for building the package.
d. Change back to the sources directory.
e. Delete the extracted source directory and any <package>-build
directories that were created in the build process.